PROJECT COORDINATION工程协调 · PROJECT DELIVERY
Use this sequence to review model data, installation details and handover records before equipment is installed.按此流程核对型号资料、安装细节和交付记录，减少设备安装前的遗漏。
01 / FROM SELECTION TO HANDOVER从设备选型到项目交付
Before installation, check that the selected model, circuit, interfaces and site conditions match the project documents.设备安装前，核对所选型号、供电回路、设备接口和现场条件是否与项目文件一致。
Open the pre-selection checklist查看选型核对清单→02 / PROJECT CHECKPOINTS项目核对流程
04 STEPS个阶段PROJECT SCOPE
Record the room use, project stage, supply conditions and circuits in scope. List any assumptions that still need confirmation.记录房间用途、项目阶段、供电条件和涉及的回路，并列出尚待确认的事项。
MODEL & INTERFACES
Compare the model code, ratings, dimensions, terminals, alarm contacts and communication interfaces with the project documents.对照项目文件核对型号、额定参数、尺寸、端子、报警触点和通信接口。
SITE CONDITIONS
Check the mounting method, access, ventilation, cable entry and service clearances. Confirm cable routes between the equipment and monitoring points.核对安装方式、检修空间、通风、电缆入口和维护净距，并确认设备至监测点的线路走向。
TEST & HANDOVER
Before commissioning, agree the inspection steps, test basis, witness points, alarm checks and records required for handover.调试前明确检查步骤、测试依据、见证点、报警核对方式及交付所需记录。
03 / RESPONSIBILITIES工作分工
Project agreements define contractual responsibilities. This list helps teams identify who should confirm each technical item.合同责任以项目约定为准。以下清单可帮助项目团队明确各项技术内容的确认方。
04 / OFFICIAL STANDARD EXTRACTS标准原文摘录
“Article 517 Health Care Facilities”“第 517 条 医疗保健设施”
“insulation resistance RF to earth of unearthed a.c. IT systems”“未接地交流 IT 系统对地绝缘电阻 RF”
“insulation fault location system (IFLS)”“绝缘故障定位系统 (IFLS)”